Відео

Where would you need this type of lock?

The 80 series are junk, look into a von duprin 99

Maximum safety when taking a shit?

Send one to the lock picking lawyer!

This looks too easy. My core won't come put

Thanks

I need RX & DM status from this lock, please assist

Question. I recently had to do this but the actual handle is now unlocked defeating the purpose of the Keypad. How can I lock the handle again?

What if the door is too hard too open ?

Plastic it just breaks, kinda like the tzones

Junk

hi , thanks for the video.But what to adjust if its hard to open the door ?

You guys need to do a video on how to read the Instructions. They are truly hard to read

Unreliable........

"PromoSM" 😥

Nice explanation. Could certainly have done without the very overpowering background music.

Help here please: I installed Sargent 77 lock and when key inserted it just spins round and round and doesn’t lock. I’m Assuming Adjusting this screw Is what I need to do in order to be able to lock from outside?

What's with the fake ass showroom green screen? Lol

New master cod-> 99# then your code (slow lED) 50#1#01# -> new master code flowed by * repeat * then just the star key.

🎉🎉 nice work

Thank you for posting 👍

You seem to have left out the "How To" part...

What about 5 where engaging the inside handle doesn't release the cylinder lock?

Thx, good video.

Hello, trying to find a video on how to undo Sargent WD8600 concealed exit device rod holder, but no luck. Could you please help?

At 3:07 the robot voice said tighten the lock body screws? I believe that after you thread the cylinder (do not secure) and install the handle (do not tighten) now tighten the lock body screws and then secure the cylinder and last tighten the rose screws and secure the handle,

Thank you!

These panic bars, 88 series are un reliable and fail all the time, please use von duprin hardware

Please stop making door hardware

Doesn’t work as advertised the lock fights against this change over.

That green spring continously breaks these trims are absolutely trash should stop making locks and hardware

The 88 series panic bar, rim device, does not hold up to high school kids at all

Can you tell me what size the allen wrech is to get to the batteries

I have this lock door and its backwards it open from the outside how do I fix it

Where’s the bind test

Thank you so much I was trying to adjust a door ,until I find your video It was very helpful.

You should supply a case of those green springs with every lever trim, they break way to frequently..

Title says "Change the hand", should say "Change function".

How do you set the lock to be unlocked on both sides

Is there a conversion kit for existing Sargent 8800 series rim devices? What would that part number be? Went through Sargents entire catalog and this product is not easy to find.

I modified mine by taking it apart 🤣 I didn't have that green screw customizable ability

How can I adjust the back check if the area is difficult to get when the door is closed (I.e., the arm is blocking the way of the hex key)? The back check is on top

Can you take off outer handle without the key

Von Duprin 98/99: I’m really stronger. The older one you have did break. Sargent 80: am I a joke to you??

Very well done. SARGENT produces great Exit Devices, very dependable and durable.

These closers suckkkk 🤣 lcn 4041 xp allll day 👌

HAHAHA, tweakers in my area have no problem destroying the t zones

Do yourself a favor and Return it and get allegion products

How do you remove the lockset if only one side has the pin hole?

that thing is a BEAST